LLNL Solenoid Gun Magnet
4/28/2011 Scott Anderson

This is the Compton type solenoid which is being measured for LLNL

Axial Field Probe Alignment:  x and y = 0 is the mechanical center of the inside cylinder.  
+X is to the right looking in the +Z direction and +Y is up. 
Z = 0 is the outside surface of the upstream end plate and +Z is into the magnet (see Axial Probe Setup 3.JPG where the probe is at Z = 0)
An axial field pointed into the probe will be recorded as positive.

Runs 8-10
Transverse and Multipole Field Probe Alignment:  
x and y = 0 is the mechanical center of the inside cylinder. 
Z = 0 is the outside surface of the upstream end plate and +Z is into the magnet. 
+X is to the right looking in the +Z direction and +Y is up. (See Setup 3 from -z end, coil at z = 0 with coordinates.JPG)   

Transverse and multipole fields vs z at magnetic center (X = -2 mils, Y = +1 mils).
Positive angles are CCW from +X horizontal looking in the +Z direction).